Page 1 of 1
Part description/measurement help
Posted: Tue May 31, 2011 9:27 pm
by john jupiter
When the timing plug is removed a bearing is visible inside the engine cover. I would like to know the inside diameter of this bearing and what the bearing is called for future reference.
Thanks
John
Clutch-cover Bearing description/measurement
Posted: Wed Jun 01, 2011 9:13 am
by DewCatTea-Bob
____ That bearing is just a (relatively cheap) std.ball-bearing 17x40 by 12mm-thick, and ought be referred to as the crankshaft's left tip-end support-bearing.
DUCATIly,
DCT-Bob
Re: Part description/measurement help
Posted: Wed Jun 01, 2011 7:04 pm
by john jupiter
"The crankshaft's left tip-end support-bearing"... It shall be called! Thanks Bob
Re: Part description/measurement help
Posted: Thu Jun 02, 2011 1:42 am
by machten
In our little group, we refer to it as the crankshaft outrigger bearing.
Kev