Part description/measurement help

Ducati single cylinder motorcycle questions and discussions, all models. Ducati single cylinder motorcycle-related content only! Email subscription available.
Moderator: Morpheus

Moderator: ajleone

Forum rules
Post Reply
john jupiter
Posts: 160
Joined: Wed Apr 06, 2011 1:00 pm
Location: USA

Part description/measurement help

Postby john jupiter » Tue May 31, 2011 9:27 pm

When the timing plug is removed a bearing is visible inside the engine cover. I would like to know the inside diameter of this bearing and what the bearing is called for future reference.

Thanks
John
1970 450 Jupiter
Top
DewCatTea-Bob
Posts: 2897
Joined: Sun Nov 01, 2009 10:53 am
Location: Near SE side of Lake Michigan

Clutch-cover Bearing description/measurement

Postby DewCatTea-Bob » Wed Jun 01, 2011 9:13 am

____ That bearing is just a (relatively cheap) std.ball-bearing 17x40 by 12mm-thick, and ought be referred to as the crankshaft's left tip-end support-bearing.

DUCATIly,
DCT-Bob
PLEASE NOTE... If this-post is not-yet signed-off with '-Bob', then I'm still in the process of completing it,, and if not also included with 'DCT' near bottom as well, then I may edit this post's wording at a later time. - Dct.Bob
Top
john jupiter
Posts: 160
Joined: Wed Apr 06, 2011 1:00 pm
Location: USA

Re: Part description/measurement help

Postby john jupiter » Wed Jun 01, 2011 7:04 pm

"The crankshaft's left tip-end support-bearing"... It shall be called! Thanks Bob
1970 450 Jupiter
Top
machten
Posts: 507
Joined: Sat Jan 01, 2011 12:57 pm

Re: Part description/measurement help

Postby machten » Thu Jun 02, 2011 1:42 am

In our little group, we refer to it as the crankshaft outrigger bearing.

Kev
Top
Post Reply

Return to “Ducati Singles Main Discussions (& How to Join)”

Who is online

Users browsing this forum: No registered users and 28 guests