Page 1 of 1
Hub rim offset, Motorans Elite
Posted: Tue Nov 17, 2020 4:20 pm
by Geordie
I am setting up front and rear with no offset relative to the hub flanges. The original wheels, as bought, were not standard spoked and may have been non-original. Therefore I did not measure for offset before stripping them. The workshop manual does not carry this information. Anyone know if the offset is zero (central) relative to hub spoke flanges?
Re: Hub rim offset, Motorans Elite
Posted: Tue Nov 17, 2020 10:04 pm
by blethermaskite
To the best of my knowledge all the ducati ohc single wire wheels are built with the rim centered to the hub flanges as you suggest.
Cheers,
George
Re: Hub rim offset, Motorans Elite
Posted: Wed Nov 18, 2020 11:16 am
by Geordie
George, thank you for that. I have laced and trued the rear to that and all worked out fine when I tried it up to a swing arm.
