Motoscrubs.com

Hello there.
An unfortunate turn in the reassembly of my US22BS, the male end on the float chamber cover sheered-off when I was tightening the cap nut that holds the banjo in place.
As such, the entire cover will need to be replaced. (as shown in the exploded diagram in Tom Baileys shop Manual on singles)

Ask - If you have a UB22BS as a parts carb, I would be willing to negotiaite the purchse of the float cover with threads on the male end in tact.

Cheers,
Andrew

Andrew,
Got out my "bucket-o-carbs" to see what I had - I believe this "straight" float chamber is for a UB22BS. It has some corrosion inside, but may be usable.

George T.

Brilliant! Where else on the planet could such a question get such a reply?

If George's isn't usable, you might find something at http://sucarb.co.uk/float-chambers-spar ... blies.html you could use - at a price.

Brian

George, that's the one! If we can organize this through PMs. I am not too far from the Illinois cornfields; Toronto, Ontario
This is the current victim:

George, PM sent.

Andrew