During reassembly I realized there are two retaining ring slots in the lower bevel gear shaft. Is one of these slots the "correct" one, or will it be a result of gear mesh and proper shimming?
Thanks!
Lower Bevel Shaft Retaining Clip Slot
Moderator: ajleone
-
blaat!
- Posts: 261
- Joined: Thu Aug 25, 2011 4:31 pm
- Location: Massachusetts
Lower Bevel Shaft Retaining Clip Slot
You do not have the required permissions to view the files attached to this post.
-
DewCatTea-Bob
- Posts: 2897
- Joined: Sun Nov 01, 2009 10:53 am
- Location: Near SE side of Lake Michigan
Re: Lower Bevel Shaft Retaining Clip Slot
" During reassembly I realized there are two retaining ring slots in the lower bevel gear shaft. Is one of these slots the "correct" one, "
____ Both are correct for THEIR-own particular intended use...
Your upper-slot (which is missing it's ring-clip), is intended to hold a clip which keeps the tower-shaft connector-sleeve centered over both lower & upper tower-shaft tip-ends !
Duke-Cheers,
-Bob
____ Both are correct for THEIR-own particular intended use...
Your upper-slot (which is missing it's ring-clip), is intended to hold a clip which keeps the tower-shaft connector-sleeve centered over both lower & upper tower-shaft tip-ends !
Duke-Cheers,
-Bob
PLEASE NOTE... If this-post is not-yet signed-off with '-Bob', then I'm still in the process of completing it,, and if not also included with 'DCT' near bottom as well, then I may edit this post's wording at a later time. - Dct.Bob
Return to “Ducati Singles Main Discussions (& How to Join)”
Who is online
Users browsing this forum: No registered users and 34 guests